-14%

USB To UART TTL SERIAL CP2102 Module

 240

Description
CP2102 chip from SiLabs is a single-chip USB to UART bridge IC. This cp2102 USB to serial requires
minimal external components.CP2102 can be used to migrate legacy serial port based devices to USB.

Features:
1. Stable and reliable chipset CP2102.
2. USB specification 2.0 compliant with full-speed 12Mbps.
3. Standard USB type A male and TTL 6pin connector.
4. 6pins for 3.3V, RST, TXD, RXD, GND & 5V.
5. Baud rates: 300 bps to 1.5 Mbps
6. Byte receive buffer; 640 bytes transmit buffer.
7. Hardware or X-On/X-O handshaking supported.
8. Event character support Line break transmission.
9. USB suspend states supported via SUSPEND pins.
10. Temperature Range: -40 to +85.
11. Size: 42mm X 15mm.
12. Weight: 4g

Out of stock

Description

Description
CP2102 chip from SiLabs is a single-chip USB to UART bridge IC. This cp2102 USB to serial requires
minimal external components.CP2102 can be used to migrate legacy serial port based devices to USB.

Features:
1. Stable and reliable chipset CP2102.
2. USB specification 2.0 compliant with full-speed 12Mbps.
3. Standard USB type A male and TTL 6pin connector.
4. 6pins for 3.3V, RST, TXD, RXD, GND & 5V.
5. Baud rates: 300 bps to 1.5 Mbps
6. Byte receive buffer; 640 bytes transmit buffer.
7. Hardware or X-On/X-O handshaking supported.
8. Event character support Line break transmission.
9. USB suspend states supported via SUSPEND pins.
10. Temperature Range: -40 to +85.
11. Size: 42mm X 15mm.
12. Weight: 4g

Pinouts:
1.  TX = Connect to Transmit Pin(TXD) of Microcontroller. This pin is RX pin of CP2102 on board.
2.  RX = Connect to Receive Pin(RXD) of Microcontroller. This pin is TX pin of CP2102 on board.
3.  RST = Normally Unconnected. Reset Pin for CP2102. Initiate a system reset by driving this pin low for at least 15 µs.
4.  GND = Should be common to microcontroller ground.
5.  3V3 = Optional output to power external circuit up to 50mA.
6.  5V = Optional output to power external circuit up to 100mA

Package Contains:

1 x USB to UART TTL Converter

Additional information

Weight 50 g
Dimensions 5 × 4 × 1 cm

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.